Spray Foam Insulation
A seamless air barrier and insulation in one step — the highest-performing option for attics, basements, crawl spaces and hard-to-seal areas.
Learn about spray foamWhat we install
Insulation Services
Spray foam, blown-in BIBS, batt and insulation removal — installed across Barrie, Simcoe County and the Kawartha Lakes area by certified applicators.
Four systems, matched to the assembly
Most houses we quote end up with a combination — foam where it seals and outperforms, blown-in or batt where a cheaper product does the same job. Here is what each one is for.
Blown-In (BIBS) Insulation
The Blow-In Blanket System packs cavities completely full — R-24 in a 2x6 wall, R-14 in a 2x4 — with excellent sound control and a drill-and-fill option for finished walls.
Learn about blown-in
BATT Insulation
Traditional fibreglass and mineral wool batts, installed properly — friction-fit, uncompressed and detailed to the Ontario Building Code.
Learn about batt
Insulation Removal
HEPA vacuum removal of old, contaminated, pest-damaged or water-damaged insulation — then we fix what caused it and re-insulate to code.
Learn about removalTwo minutes
Which insulation do I need?
Three questions. No email, no phone number, no sales call — just the product that usually fits, and the honest reason why.
Our best guess
Read about it Get a free quote
This points you at the right starting product. It cannot see your building, so the free on-site assessment is what confirms it — and we will tell you if a cheaper product does the same job.
Straight comparison
Spray foam vs. blown-in vs. batt
The honest differences, including where the expensive option is not worth paying for.
| Spray Foam | Blown-In (BIBS) | BATT | |
|---|---|---|---|
| R-value per inch | Highest (about R-6/in) | Medium | Medium |
| Air barrier | Yes — seals as it expands | No | No |
| Vapour retarder | Yes, at normal thickness | No | No |
| Fills irregular cavities | Completely | Completely | Only if cut and fitted well |
| Settling over time | None — bonded in place | None — blown to density | Can sag or gap if poorly fitted |
| Sound control | Good | Excellent | Good (best with mineral wool) |
| Works in finished walls | No | Yes — drill-and-fill | No |
| Relative cost | Highest | Middle | Lowest |
| Best used for | Attics, rim joists, crawl spaces, cathedral ceilings, retrofits | Walls, attics, sound walls, drill-and-fill | Open, standard, dry framing in new builds |
Not sure which one you need?
That is the normal starting point, and it is exactly what the free quote visit is for. We get into the attic, basement or crawl space, find where the heat and air are actually going, and tell you what each area needs — including the areas that do not need anything.
NEEDS: your Instagram bio and Facebook page both list Fireproofing / fireproof coatings, but the old website never mentioned it. Confirm whether you want a fifth service page for it — it is a strong commercial lead source and no competitor in Barrie is ranking for it
Spray Today, Save Tomorrow
Get a free, no-obligation quote
Tell us what the building is doing and we will come out, get into the space and give you a straight answer in writing.
- Free, no-obligation quote
- Straight answers on what your home actually needs
- Licensed, insured and certified applicators